IDX Cam-Wave Wireless HD Video Transmission System CW-5HD

The Cam-Wave Wireless High Definition Video Transmission System by IDX provides a High Definition signal that can be viewed wirelessly as much as 150 feet away. It is an uncompressed wireless transmitter and receiver system for both HD-SDI and SD-SDI video signal processing. Multiple formats of video with two channels of SDI embedded audio. Transmission delay less than 1ms. Maximum range up to 100 feet (30m) through walls and up to 150 feet (50m) in line-of-sight conditions. Use in actual production may vary. It ships with an IDX V-Mount, allowing a direct attachment to an IDX battery for rear mounting on a camera or can be attached for DC operation via 4-pin XLR connector. It's a sleek and lightweight; weighing just 1.76 pounds, with no visible antenna array. Wireless transmission via MIMO/OFDM, operating between 5.1 - 5.8GHz frequencies. No special FCC license is required. Selection of four manual or auto-select frequencies with 256-bit encryption. TX features loop-through; RX outputs dual simultaneous signal. Unicast and multicast link mode selection. Confomance to major international engineering standards including FCC, CE and RoHS specifications. IDX provides the 3-stud adaptor installation as a courtesy.

Specifications:

• Frequency: 5.18GHz – 5.86GHz
• Tuning Range / Frequency selection: Four Selectable Channels or Auto Select
• Transmit Power: 89mW maximum
• Transmit Antenna: Internal 2dBi gain
• Transmit Method: MIMO
• Modulation: OFDM
• Latency: Less than 1ms
• Video Input: HD-SDI-SMPTE 292M / SD-SDI-SMPTE 259M-C (Auto-Sensing)
• Supported Video Profiles: HD-1080i/59.94, 1080i/50, 1080p/29.97, 1080i/23.98PsF 720p/59.94, 720p/50 SD-525i/59.94, 625i/50
• Audio Input: Two Channels SDI embedded Power Requirement: 10 – 17 VDC via battery plate or 4 pin XLR connector
• Power Consumption: 12W approx.
• Dimension (WxDxH): 158mm x 62mm x 188mm (6.23" x 2.44" x 7.41")
• Weight: Approx. 800g (1.76lbs)
• Operating Range: 0~40°C (32~104°F)