ARRI Handle Extension Set for ALEXA 35

The Handle Extensions follow the design of the Camera Center Handle CCH-4. The number of each HEX refers to the number of 3/8-16 interfaces on the top (HEX-1 has one and HEX-5 - five). They can be connected in multiple ways in order to extend a top handle but also to build your own handle design. Every HEX offers a 3/8-16 screw at the front (ARRI Multi-HEX screw with 4 different tool options) with two anti-twist locating pins and the corresponding thread interface at the back. Multiple RMB-3, as well as 1/4-20 interfaces are included as well. The system can also be used to build a so-called "Hollywood Handle". This allows to operate the camera from the back without touching the on-board battery.

The Handle Extension Set for ALEXA 35 includes the Handle Extension HEX-A and comes in a foam inlay that fits in a Pelican 1170 case (Pelicase not included).

Includes:

• 1x Handle Extension HEX-1
• 1x Handle Extension HEX-2
• 1x Handle Extension HEX-3
• 1x Handle Extension HEX-4
• 1x Handle Extension HEX-5
• 1x Handle Extension HEX-90
• 1x Wooden Shell for HEX
• 1x Handle Extension HEX-A

Maximum Load:

• HEX-1 - 90kg
• HEX-2 - 80kg
• HEX-3 - 50kg
• HEX-4 - 40kg
• HEX-5 - 30kg
• HEX-90 - 60kg
• HEX-A - 75kg

*Please note that the maximum load is only referring to the use of one single HEX, when another HEX will be attached the maximum load will be reduced.