Glidecam X‑10 Dual Support Arm Stabilizer Vest System
- Professional camera stabilization system
- For use with 2000/4000 Pro, HD2000/HD4000, XR 2000/4000
- Support arm movement
- Lightweight, comfortable support vest
The Glidecam X‑10 Dual Support Arm Stabilizer Vest System is a highly advanced, professional camera stabilization system designed for specific Glidecam stabilizers. The system works by isolating your body's motion from the camera leaving a motionless and isolated stated. This state allows you to operate the support arm which can be boomed up and down or pivoted in and out or side-to-side for smooth camera control. The stainless steel arm helps prevent your movement from disturbing the camera to create smooth camera footage. The X-10 system is perfect for virtually any situation whether you're going up or down or moving in vehicles or uneven terrain.
When properly balanced, the Glidecam X-10 can support Glidecam XR-2000, XR-4000, XR-PRO, HD-2000, HD-4000 and the DEVIN GRAHAM Signature Series Glidecam Hand-held Stabilizers for beautifully controlled and stable shots. The support arm incorporates 38 precision radial bearings within its aluminum structure with an implementation that produces minimal friction with virtually no noise. The Inter-X-Change system makes installing and removing springs quick and easy to allow the support arm to be configured in a Two-Spring or four-Spring mode. These modes can support cameras weighing up to 8 and 18 lbs respectively.
Lightweight and comfortable, the Glidecam X-10 Support Vest can be adjusted to fit a wide range of operators. Constructed of high endurance, dual density, EVA foam padding and integral T6 aluminum alloy, the advanced vest holds and evenly distributes the weight of the system across the operator's shoulders back and hips. For safety, quick release, high impact buckles allow the vest to be removed quickly. The Vest’s outer shell is made of 1000 denier cordura fabric, and 7-panel seat belt strapping, noted as being the best in the industry.
The Glidecam X-10 Support Vest incorporates a unique and proprietary Arm-to-Vest Connector that allows the angle of the Support Arm to be adjusted relative to the Support Vest. This Trimming Mechanism allows you to neutralize the weight of the Support Arm relative to your body’s center of gravity. When set correctly the effort required while shooting is greatly reduced. Another unique and proprietary feature of the Arm-to-Vest Connector is that it allows the Support Arm to be attached and removed from the Vest without affecting the operator’s selected trim settings.